-as of [5 OCTOBER 2025]-
.
*HOLE SIZES* —>
*[USB 2 MICRO-B]* —>
.
*USB-A* —>
.
-USE A [LIGHTER] TO BURN [HOLES] INTO THE [PLASTIC] ON [LEFT/RIGHT] SIDES-
-USE [SIZZERS] TO WIDEN THE [HOLES]-
-THREAD YOUR [WIRE JACKS] THROUH THESE [HOLES]-
-IF THERE IS A “MALE SIDE” + “FEMALE SIDE”, THREAD THE CABLE WITH THE “MALE SIDE” THROUGH THE “RIGHT SPOT JAR HOLE” + “LEFT SIDE HOLE”-
-MOVE THE “SPOT JAR” TO THE CENTER OF THE “CABLE”-
,
-WRAP “RIGHT INDEX FINGER” AROUND THE “THREADED CABLE” UNTIL EACH “ENDPOINT” OF THE CABLE IS NEAR THE BOTTOM OF THE “SPOT JAR”* —>
.
*LOOP EACH “CABLE ENDPOINT” THROUGH THE “TOP HOLE” + OUT “SIDE HOLE” AGAIN* —>
.
-REMOVE [CABLES] FROM [SPOT JAR]-
-PUSH BOTH “CABLE ENDPOINTS” INTO THE “SPOT JAR”-
-IF THEY HAVE BEEN LOOPED AROUND THE [“SIDE HOLE” / “TOP HOLE”]. PULL EACH ENDPOINT “OUT OF THE “TOP HOLE”-
-THEN PUSH EACH “ENDPOINT” BACK INTO THE “SPOT JAR”-
-THEN PULL THE CABLE OUT THE “TOP HOLE”-
.
.
*👨🔬🕵️♀️🙇♀️*SKETCHES*🙇♂️👩🔬🕵️♂️*
.
.
.
.
💕💝💖💓🖤💙🖤💙🖤💙🖤❤️💚💛🧡❣️💞💔💘❣️🧡💛💚❤️🖤💜🖤💙🖤💙🖤💗💖💝💘
.
.
*🌈✨ *TABLE OF CONTENTS* ✨🌷*
.
.
🔥🔥🔥🔥🔥🔥*we won the war* 🔥🔥🔥🔥🔥🔥